Hayward pool VAC helps to clean the pool. It is an automatic system of cleaning the pool. It works very efficiently and smartly. It is compatible with most the pool filter system. Its performance and operation is very reliable. Hayward offers innovative products which work quietly. Its filtration system cleans the pool thoroughly.
Features of Hayward pool VAC:
It ensures entire pool coverage due to the presence of steering pattern which is Aqua Pilot programmed.
Additional equipments are not required.
It operates silently due to the turbine technology.
It connects in just 10 minutes therefore it is easy to use.
Existing filtration system gives it the power.
Hayward pool VAC should be properly installed for maximum benefit and use. It cleans the bottom thoroughly and even climbs the walls.
Tips to keep in mind while using Hayward pool VAC:
The hose section of the cleaner should not be coiled while storing.
The cleaner should be held with the handle to prevent any damage and avoid disconnection of the hose from the cleaner.
To check the efficiency of the vacuum checks the inflow of water periodically.
The hose should be attached to the suction source which needs periodic checking.
Disconnect the hose from the regulator valve to prevent restricted water flow.
Do not coil the hose as it is not covered under the warranty period.
The hose should be disconnected from the navigator head when not in use and is out of the pool.
Remove it from the pool while swimming in the pool.
Before adding gas chlorine to the pool, the cleaner and the hose should be removed.
Maintenance of Hayward pool VAC:
The condition of flaps, shoes and wings should be checked periodically. They should be replaced if not in good condition.
Shoe replacement should be done if required. By turning the unit upside down and using a lifting motion shoe can be replaced.
Wings can be replaced by bending then and lifting them. Attach them properly for better functioning.
The rear and front flaps should be removed. Install them properly as the flaps are different.
Bumper replacement: the propulsion system can be problematic if you try to change it yourself. You need to consult the dealer for its replacement.
For better cleaning and proper maintenance allow quick access to vacuum chamber by using easy opening button system.
Problems that can occur while using Hayward pool VAC:
Lack of improper flow of water can cause slow movement. In such case you should check the water flow in the flow gauge. Clear the blockage in case of no water flow. Improper functioning of shoes, worn out shoes and worn out wings can prevent the cleaner from climbing the vertical walls. The cleaner can even fail from climbing the wall if the hose is too short and the throat of the cleaner is partially blocked. Improper water flow can cause the cleaner to suck air from the water surface. Hayward pool VAC is a cost saving solution to clean the pool thoroughly and efficiently.
